A preferred customer is a customer who has a Preventative Maintenance Agreement with us. This is a prepaid annual service so we can make sure the system is in top running condition at the start of every season.
20 Point Maintenance Checklist
- Clean Burner Assembly to improve combustion, reducing waste heat
- Tune Burners for more efficient burns, saving energy
- Clean Ignition Assembly to ensure reliable operation on demand
- Clean & Inspect Furnace Heat Section to ensure safe operation and the absence of cracks from metal fatigue
- Verify Flue Draft to ensure dangerous gas by-products are properly venting to the outdoors and flue pipes are free from obstruction
- Inspect Flue Pipe to ensure no corrosion is present which can lead to cracks and the introduction of dangerous fumes into your home
- Calibrate Thermostat for accurate control and to prevent system from running longer than necessary, increasing utility usage
- Test Refrigerant Charge to ensure optimum levels leading to lower utility usage and extend compressor life
- Test Capacitors to ensure reliable operation and continued compressor and motor protection
- Test Crankcase Heaters to ensure proper compressor protection
- Inspect & Test Controls & Safeties to keep operating costs low and prevent failures
- Clean or Replace Filters to reduce energy use, reduce compressor strain, improve indoor air quality, and improve comfort.
- Check Airflow to ensure proper air flow across the coil for proper humidity removal and reliable operation
- Visually Inspect Ductwork to identify obvious leaks, which reduce system efficiency and increase utility expense
- Tighten Electrical Connections to ensure uninterrupted system operation
- Measure & Record Voltage & Amperage to identify baseline operating conditions
- Lubricate All Moving Parts to maintain efficiency and extend equipment life
- Clean Inside Evaporator Coil to restore heat transfer efficiency, reduce utility cost, and improve air quality
- Clean Outside Condensing Coil to restore heat transfer efficiency and reduce utility cost
- Clean Condensate Drains to prevent water damage and the potential for mold formation
Return Your Comfort System to “Factory Fresh” Conditions
- Annual Tune Up Service Call
- 20 point Inspection
- Combustion Adjustment, Professional Cleaning, & Safety Inspection
- 10% Off Parts
- Free Priority Service
- No Overtime Charges up to 8:00PM on Weekdays (must be scheduled by 2PM the previous day)
- Discounts on Future Equipment Purchases
